Step-By-Step Programming; Starting The Rinsing Program; Start Descaling Program - BRAVILOR BONAMAT Bolero 10 Operating Instructions Manual

1.8 Step-by-step programming

1.8.1 S
TARTING THE RINSING PROGRAM
1. Select the rinsing program. Figure 5
now appears in the display.
2. Place a cup under the beverage
outlet (14).
3. Press on the right-hand side of the
ß(13). The rinsing
start button
program now flushes the machine
with hot water. This runs into the cup.
4. Discard this water.
5. Repeat steps 3 and 4 until the water
in the cup is clear. Press the
programming key to return.
6. The machine is again ready for use.
1.8.2 S
TART DESCALING PROGRAM
1. Open the door (10) and flip the cover
(9) up.
2. Remove the ingredient container (2)
and the drip-tray (15).
3. Press the programming key (3).
4. Select the descaling program with
selection key
appears in the display.
5. Press the right-hand side of the start
ß (13).
button
− Cancelling the descaling
program, see point 25.
6. Pull out the drain hose (5).
7. Place the drain hose (5) over the
edge of a bucket that can hold at
least 7 litres.
6
Fig. 5
Fig. 6
(12). Figure 6
8. CARE! Water that is leaving the hose
may be hot! Remove the drain plug of
the drain hose (5) to allow the water
out into the drain or the bucket.
9. Replace the plug on the hose.
10. Gently remove the hose (4.3) from the
mixer chamber (4.2) and place it over
the edge of a bucket.
11. Dissolve 100 grams Renegite in
approx. 0,5 litre warm water.
12. Remove the plug from the descaling
inlet (8).
13. Use a funnel to pour the descaling
solution into the descaling inlet (8) and
close the inlet again with the plug.
14. Leave the Renegite solution for a few
minutes to take effect.
15. Press on the right-hand side of the
ß(13). The descaling
start button
program now starts and will last for
approx. 15 minutes. The machine will
be rinsed with water.
16. Tap a few cups of water through the
hot-water tap to flush the hot-water
outlet.
17. Remove the drain plug of the drain
hose (5) to allow the water out into
the drain or the bucket.
18. Replace the plug on the hose.
19. Replace the ingredient container (2).
20. Replace the drain hose (5) in its
original position and close the lid and
the door.
21. Replace the drip-tray (15).
22. Press the programming key (3). The
machine will now fill with water and
the water will be heated.
23. The machine is again ready for use.
24. The descaling signal is now
automatically reset .
PRECAUTIONARY MEASURE
• Stay with the machine throughout the
descaling process.
• Wear gloves and a facial protector
while descaling.
**