Settings; General Programming Procedure; In General; Activating The Settings Program - BRAVILOR BONAMAT Bolero 10 Operating Instructions Manual

Hot beverage brewer
Hide thumbs Also See for Bolero 10:
Table of Contents

Advertisement

1.6 Settings

The machine is equipped with a program
that allows you to set all the facilities of
the beverage maker. The program
comprises nine components in the
following sequence:
1. Starting rinsing program.
2. Starting descaling program.
3. Setting the quantity of beverage per
cup.
4. Setting the strength of beverage per
cup.

1.7 General programming procedure

1.7.1
I
N GENERAL
Before you start programming, remember
which settings have to be changed.
Make a note of the settings you wish to
change. You can then enter all the
changes in one go, one after the other.
An explanation of the different setting
possibilities is given in § 1.8 trough 1.11.
1.7.2
A
CTIVATING THE SETTINGS PROGRAM
1. Open the door with the key (19).
2. Switch on the machine. Set switch (1)
to the 'on' position, which shows a red
indicator side at the switch.
3. Press the programming button (3) on
the inside of the door.
4. The number of brewed cups of
beverage, see figure 4, appears in
the display (11) on the outside of the
door.
5. Setting the mixer on or off for cups.
6. Setting the quantity of beverage per
7. Setting the mixer on or off for
8. Setting the temperature of hot water
9. Setting the descaling signal.
5. Attention! The program returns to
6. Press selection key
7. Press selection key
1.7.3
1. If you have finished setting up the
2. Check whether the changed
Fig. 4
decanter or switch off decanter
option.
decanters.
and beverage.
normal mode after 10 seconds. Press
again the programming button (3).
cleaning program will appear in the
display, see figure 5.
to proceed to the next possible
program/setting.
In this manner you can use the
selection key
to run through all
the settings in the program. The
display shows what can be set after
each step.
C
LOSING THE SETTINGS PROGRAM
program, press the programming
button (3) on the inside of the door
again. The new settings will now be
saved.
setting(s) from point 3 to 8 of § 1.6 is
(are) according to your requirements,
by tapping of a cup or decanter. If
not, change the setting(s) until it/they
complies/comply with your wishes.
(12). The
(12) again
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Bolero 11

Table of Contents