Tep By Step Programming; Setting The Hot Water Temperature; Setting Descaling Signal - BRAVILOR BONAMAT Bolero 10 Operating Instructions Manual

1.11 Step by step programming (continued)
1.11.1 S
ETTING THE HOT WATER
TEMPERATURE
1. Select program 'setting the hot water
temperature'. Figure 16 appears in
the display.
2. The setting ranges from 80 C through
90 C.
3. Select the required setting with the
start button .
− press on the right-hand side of the
setting key
temperature.
− press on the left-hand side of the
setting key à
temperature.
4. The default setting is 85°C.
Fig. 16
ß for a higher water
for a lower water
1.11.2 S
ETTING DESCALING SIGNAL
1. Select program 'setting descaling
signal', see figure 17.
− The setting ranges from 0 through 5.
− This setting allows you to set the
number of litres of beverage that
can be brewed, after which the
machine must be descaled.
− This setting depends on the
hardness of the water. The harder
the water, the sooner descaling is
necessary.
Setting Number of
litres
no signalling
1 ± 250 litres 18 till 30 hard
2 ± 500 litres 12 till 18 fairly hard
3 ± 1000 litres 8 till 12
4 ± 1500 litres 4 till 8
5 ± 2000 litres 0 till 4
°
4,0 dH = 0,714 mmol/litres
°
5,6 dH = 1,000 mmol/litres
°
8,0 dH = 1,429 mmol/litres
°
12,0 dH = 2,143 mmol/litres
°
18,0 dH = 3,214 mmol/litres
°
30,0 dH = 5,357 mmol/litres
2. Select the required setting with the
setting key
− press on the right-hand side of the
setting key
− press on the left-hand side of the
setting key
3. The default setting is: ± 1000 litres,
setting 3.
Fig. 17
Water hardness
°dH description
average
soft
very soft
ß(13).
ß (=ascending).
ß (=descending)
9