Sage; Hot-Water Tap; Stopping The Brewing Process - BRAVILOR BONAMAT Bolero 10 Operating Instructions Manual

1.12 Usage
1. Insert the plug into an earthed wall
socket.
2. Open the door (10) on the left-hand
side with the key (19).
3. Open the top cover of the machine
(9).
4. Remove the lid (2.1) from the
ingredient container.
5. Fill the ingredient container with the
special ingredients available for these
machines.
6. Replace the lid on the ingredient
container.
7. Switch on the machine. Set switch (1)
to the 'on' position, which shows a red
indicator side at the switch.
8. Close the top cover (9).
9. Lock the door with the key (19).
10. A coffee cup appears in the display
(11). In the top right-hand corner a
flashing thermometer appears, see
fig. 3. As soon as the water is at the
correct temperature the thermometer
will disappear.
11. Place an empty cup under the
beverage outlet (14).
12. Press the start button
13. The beverage will run into the cup.
14. It is also possible to tap a half or a
whole decanter of beverage.
15. Pushing the selection key
once, or twice in a row enables you to
tap a whole decanter or half a
decanter respectively. The display
(11) subsequently shows half a
decanter and a full decanter.
16. Place an open and empty decanter
under the beverage outlet (14) when
the whole or half-decanter setting is
selected.
10
17. Press the start button
18. If the water temperature is too low, a
19. Tapping beverage is temporarily
1.12.1 H
1.12.2 S
When the decanter setting is selected
.
and the start button
although only cups are needed, it is
possible to halt the brewing process.
Halt the brewing process by pressing the
(12)
start button
the start or by pressing the selection key
process, a one cup beverage will still run
into the cup.
seconds of selecting one of the
decanter settings. If you wait any
longer, the machine automatically
returns to the cup setting.
thermometer appears in the display,
see figure 3.
blocked. As soon as the water has
returned to the correct temperature, a
cup appears in the display. From this
moment on it is possible to tap
beverage once again.
-
OT WATER TAP
1. The hot-water tap is intended for
filling a cup occasionally.
2. The hot-water tap (18) is not blocked
when the water temperature is too
low.
3. It is unadvisable to draw hot water
during drawing beverage.
TOPPING THE BREWING PROCESS
again immediately after
. Although this stops the brewing
within five
is pressed,