Table of Contents
Advertisement
Figure 3.
Back Focus Set-Screw Locations
2.2.5
Auto-Iris Lens Setup
Auto-iris lenses with full video input can be used with the JAI, Inc. TMC-775 and TMC-773.
Note: Make sure that the power is removed from the camera before connecting or disconnecting the auto-iris
lens. There is a small chance that damage could occur to the auto-iris lens by plugging or unplugging it
while the camera is powered up.
Power down the camera before installing the auto-iris lens. To install the auto-iris lens in a JAI, Inc. camera, wire
the signal on the lens into the 1 V peak-to-peak video output (pin 11) on the camera. 12 volts DC is available on
pin 3.
Point the camera at a light area and then quickly towards a darker area. If everything is working properly, the iris
should adjust for the light change.
2.2.6
Monitor Display Mode
For monitoring real time video, connect the video output to an NTSC video monitor or other device.
2.2.7
Connectors and Cables
15-pin connector and cable: Standard cable is 15P-02-9P and 15P-02-9P-FULL.
Figure 4.
15P-02-9P Cable
16
Hardware Installation
TMC-775/TMC-773
Advertisement
Table of Contents
