Repeat Playback; Instant Review; Soundtrack Selection - JVC HR-S9600EU Instructions Manual

Repeat Playback

Your video recorder can automatically play back the whole tape
50 times repeatedly.
START PLAYBACK
1
Press PLAY.
ACTIVATE REPEAT PLAYBACK
2
Press PLAY and hold for over 5 seconds, then release.
The Play indicator ( ) on the display panel blinks
slowly.
The tape plays 50 times automatically, and then
stops.
STOP PLAYBACK
3
Press STOP at any time to stop playback.
NOTE:
Pressing PLAY, REW, FF or PAUSE also stops Repeat Playback.

Soundtrack Selection

Your video recorder is capable of recording three soundtracks (HI-FI L, HI-FI R and NORM) and will play back the one you select.
During Playback
Pressing AUDIO on the remote control or AUDIO MONITOR on the recorder changes the soundtrack being played back as
follows:
TRACK
Recorder's Front Panel
+
NORM
+ + NORM
On-Screen Display
HI FI
For Hi-Fi stereo tapes
L R
HI FI
For main audio of Bilingual tapes
L
HI FI
For sub audio of Bilingual tapes
R
NORM For audio-dubbed tapes
HI FI
For audio-dubbed tapes
NORM

Instant ReView

Simply by pressing a single button, the recorder power comes
on, rewinds, and begins playback of the last timer-recorded
programme. If you have several programmes recorded, you can
easily access any of them.
NOTE:
Before starting, make sure that the recorder is off and that the
Timer mode is disengaged.
ACTIVATE INSTANT
REVIEW
1
Press REVIEW. The recorder power comes on and the
recorder searches for the index code indicating the start
of the last timer-recorded programme. Once it's found,
playback begins automatically.
The front display panel tells you how many programmes
have been timer-recorded. If you have, for example, 3
programmes, "REVIEW" and "3" appear and blink. The
REVIEW indicator on the recorder also blinks. To
watch the first of the 3 programmes, press REVIEW
three times. The recorder searches and begins playback
automatically. You can access a programme as far as 9
index codes away from the current tape position.
NOTES:
Instant ReView is not possible while the recorder is in the
Timer mode.
The number of recorded programmes will not be displayed on
the front display panel after Auto Satellite Prog recording
( pg. 35).
NOTES:
USE
EN
" + " should normally be selected.
In this mode, Hi-Fi stereo tapes are
played back in stereo, and the normal
audio track is played back
automatically for tapes with only
normal audio.
For instructions on recording stereo
and bilingual programmes, refer to
page 25.
"O.S.D." must be set to "ON" or the
on-screen displays will not appear
( pg. 11).
19