Table of Contents
Advertisement
Audio Dubbing
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
CD Player etc.
Mixer output
Original sound
AUDIO OUT
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
NOTES:
When monitoring the sound during Audio Dubbing, the normal
soundtrack is automatically selected. If you wish to hear the mixed
sound (Hi-Fi + Normal soundtracks), press AUDIO MONITOR on
the remote control to select "L+R+NORM" (
Audio dubbing stops automatically when the counter reaches
"0:00:00", and the recorder enters the Play mode. Check the
counter reading before dubbing.
Audio dubbing is also possible using the rear panel AV1 IN/
OUT or AV2 IN connector. When using these connectors,
make sure to select the correct input mode in step 2.
Audio dubbing cannot be performed on a cassette that has
had its record safety tab removed.
When playing back an audio-dubbed tape, press AUDIO
MONITOR on the remote control to select the soundtrack
you wish to hear (
pg. 18).
8
CD Player etc.
Audio mixer
8
pg. 18).
Audio dubbing replaces the normal audio sound of a previously
recorded tape with a new soundtrack.
Normal audio track
Video/Hi-Fi audio
track
MAKE CONNECTIONS
1
Connect an audio component to the AUDIO IN L + R
connectors on the recorder's front panel.
When connecting monaural equipment, use only the
recorder's AUDIO IN L connector.
SET INPUT MODE
2
Press NUMBER key "0" or TV PROG so that "F-AU"
appears in place of a channel number.
Refer to "To Select The External Input Mode" on page
35.
LOCATE START POINT
3
Press PLAY to start playback of the tape in your
recorder, and press PAUSE when you find the point
where you want to start dubbing.
ENGAGE AUDIO DUBBING
4
Press A. DUB.
Your recorder enters the Audio Dubbing Pause mode.
("
" blinks, "
display panel.)
To perform audio dubbbing with audio mixing, press
AUDIO MONITOR on the remote control to select "L
+ R" at this point. *Audio dubbing with audio mixing
is not possible if you're using a monaural audio
component, or if you don't have an audio mixer.
START DUBBING
5
Engage the audio component's Play mode, then press
PLAY to start the tape in your recorder. Audio dubbing
begins at this point.
"
" blinks and "
display panel.
To stop dubbing temporarily, press PAUSE. Press
PLAY to resume dubbing.
END AUDIO DUBBING
6
Press STOP to stop the tape in your recorder, and
engage the audio component's Stop mode.
EN
Pre-recorded tape
Audio-dubbed tape
" and "
" light up on the front
" is displayed on the front
39
Hide quick links:
Advertisement
Table of Contents
