JVC HR-S9400E Instructions Manual page 21

TimeScan
Names of
special-effects
playback
Speed SP -9x -7x -5x -3x
Speed LP
Audio output
* Still mode cannot be engaged using the remote control's PUSH JOG button. In the Still mode, the TIME
SCAN indicator does not light even though you can hear TimeScan audio.
The recorder's TIME SCAN indicator lights during TimeScan.
The speed is shown during TimeScan in the upper right corner of the TV screen for approx. 5 seconds. (The display may be
distorted.)
To resume normal playback, press PLAY.
When using the recorder's TIME SCAN SHUTTLE ring, the playback speed may not change depending on how far it is turned.
Picture and audio may become distorted when the recording speed changes. When this happens, resume normal playback
once, and then try using TimeScan again.
The picture may be noisy or there may be a loss of colour when you change the playback speed. (More noise will appear with
LP recordings.)
Noise may appear or the upper part of the picture may be distorted during still, frame-by-frame playback, 2x search of LP
recordings, or depending on the tape being used.
Picture may appear distorted in comparison to normal playback.
In TimeScan mode there will be a time lag between the video and the audio and noise may appear in the audio signal.
TimeScan sound quality will differ in comparison to normal playback.
When the playback direction is reversed, it takes approximately 6 seconds until sound is heard.
Picture will be monochrome with an LP-recorded MESECAM tape during TimeScan.
If you don't want to hear TimeScan audio, set "TIME SCAN AUDIO" to "OFF" (
Reverse
Search Play
-1x
-7x -3x
Audio is output.
Slow-Motion *Still
-1/6x -1/18x 0
-1/6x -1/18x 0
Audio is not Audio is
output. output.
Forward
Slow-Motion Play
1/18x 1/6x 1x
1/18x 1/6x 1x
Audio is not
Audio is output.
output.
pg. 22).
21
EN
Search
2x 3x 5x 7x 9x
2x 5x 9x