Video Channel Set - JVC HR-S9400E Instructions Manual

10
EN
Video
Channel Set
Video Channel (RF Output Channel) is the channel on
which your TV receives picture and sound signals from the
video recorder through the RF cable.
• •
• • • •
• • • •
• • • •
• • • •
• • • •
TEST SIGNAL
To view picture signals from the video recorder, set
your TV to the Video Channel.
2
1 2 3
4 5 6
7 8 9
0
4
TV PROG
OK
The channel on which the screen to
the left appear clearly in step 2 is
your Video Channel.
If you have connected the video recorder to your TV
via the provided RF cable only (RF connection) – Go to
"With RF Connection" below.
If you have connected the video recorder to your TV
via both the provided RF cable and a 21-pin SCART
cable (AV connection) or via the provided RF cable, the
provided S-Video cable and the provided audio cable
(S-VIDEO connection) – Go to "With AV or S-VIDEO
Connection" on next page.
IMPORTANT:
Before performing the following steps, make sure the
recorder's power is off and there is no cassette inserted in
the recorder.
With RF Connection
ACCESS VIDEO CHANNEL
8
SET MODE
1
Hold down STOP on the recorder until the display
panel shows the following.
SET VIDEO CHANNEL
2
Set your TV to UHF channel 36.
If the two vertical white bars appear clearly on the
screen as shown in the illustration at bottom left, go
to step 3.
If the two vertical white bars do not appear clearly,
press TV PROG + or – to set the video recorder to a
vacant channel between 22 and 69 which is not
occupied by any local station in your area.
(Ex.) If channel 50 is available in your area
Then set your TV to UHF channel 50 and check if the
two vertical white bars appear clearly on the screen; if
so, go to step 3. If not, re-set the video recorder to
another vacant channel and try again.
NOTES:
If you set the video recorder to a channel which is
occupied by a local station or has neighbouring
channels that are occupied by local stations, the
picture reception quality will be affected and some
interference noise will appear on the TV screen. Be
sure to select a vacant channel which has no
broadcast on neighbouring channels.
If you cannot obtain the two vertical white bars
clearly with any channel between 22 and 69, consult
your JVC dealer.
EXIT VIDEO CHANNEL SET
MODE
3
Press OK.
INITIAL SETTINGS (cont.)