Select Language - JVC HR-S9400E Instructions Manual

If you are referring to the on-screen display
Press PUSH JOG% fi to move the highlight bar
(pointer) to your country's name.
If you have selected a country other than BELGIUM
or SUISSE, go to step 4.
If you have selected BELGIUM or SUISSE, go to step 3.

SELECT LANGUAGE

3
Press OK. the Language Set display appears on the front
display panel and/or on the screen.
If you are referring to the front display panel
Press PUSH JOG % fi to select your language code
referring to the chart in the left column.
(Ex.) DEUTSCH is selected for SUISSE
International telephone
country code
If you are referring to the on-screen display
Press PUSH JOG% fi to move the highlight bar (pointer)
to the language of your choice.
For HR-S9400E
NEDERLANDS
ITALIANO
FRANCAIS
DEUTSCH
ENGLISH
[ 5 ∞] =
[MENU] : ENDE
PERFORM AUTO SET UP
4
Press OK.
"Auto" appears on the display panel and blinks; do
NOT press any button on the recorder or remote
control until the display panel shows the current
time or "CH1" or "--:--". (Refer to box on this page.)
Auto channel set function takes place first; it assigns
automatically all receivable stations in your area.
Auto clock set function sets the clock automatically
by reading the clock setting data from a station
transmitting a PDC signal while auto channel set is
being performed.
During auto channel set, the recorder recognizes each
station name of the detected stations and stores them
in the recorder's memory, then automatically sets
S V assigned Guide Program number for those
HOW IEW
stations according to the broadcast area.
NOTE:
In the area where no TV station transmits a PDC signal,
the recorder can perform neither auto clock set nor
auto Guide Program number set.
Language code
For HR-S9400EH
NEDERLANDS
CASTELLANO
FRANCAIS
DEUTSCH
ENGLISH
[5 ∞ ] =
[MENU] : ENDE
Language Code for the HR-S9400E
ENGLISH : 01 ITALIANO
DEUTSCH : 02 NEDERLANDS : 05
FRANCAIS : 03
Language Code for the HR-S9400EH
ENGLISH : 01 CASTELLANO : 04
DEUTSCH : 02 NEDERLANDS : 05
FRANCAIS : 03
Auto Set Up results appear on the front
display panel
If Auto Set Up is completed, go to page 8.
NOTES:
If you are using the on-
screen display, the AUTO
SET screen will appear after
pressing OK in step 4. As
Auto Set Up progresses, the
" " mark on the screen
moves from left to right.
If there is a power cut, or if
you press or MENU
while Auto Set Up is in
progress, Auto Set Up will
be interrupted; be sure to
turn off the recorder power once and try again from step 1.
EN
: 04
When both auto channel
set and auto clock set have
been completed success-
fully the correct current
time will be displayed.
When auto channel set has
been completed success-
fully but auto clock set has
not, "CH" will be displayed.
When neither auto
channel set nor auto clock
set has been completed
successfully, "--:--" will be
displayed.
AUTO SET
PLEASE WAIT
+ +
0
[MENU] : EXIT
Beginning
7
+
End