JVC HR-S9400E Instructions Manual page 19

Scene Finder
This function helps you check contents of unlabeled recorded
tapes at the touch of a single button.
Search
FF REW FF
5 seconds 10 minutes
on counter
NOTE:
Scene Finder cannot be used when the recorder is in the Record
mode.
ACTIVATE SCENE FINDER
1
Press SCENE FINDER. The recorder starts forward
search for 5 seconds and then fast-forwards 10 minutes
on the counter. This cycle is repeated until the end of
the tape is reached.
To start Scene Finder in the reverse direction, press
SCENE FINDER and then press the REW button
within 2 seconds. This cycle is repeated until the
beginning of the tape.
During Scene Finder, the following indications appear
on the display panel:
STOP SCENE FINDER
2
Press STOP.
NOTES:
During Scene Finder search, you can also hear the tape
sound. During fast forward or rewind, you hear the current TV
sound instead.
During Scene Finder, the sound can be heard regardless of
"TIME SCAN AUDIO" setting.
Scene Finder does not function during Index Search.
Next Function Memory
You can set your recorder's power to go off automatically after
the tape is fully rewound. Before starting, make sure the
recorder is in the Stop mode.
For Automatic Power Off After Tape Rewind . . .
. . . press REW, then press
NOTE:
If you want the power to be turned off automatically when the
counter reads "0:00:00" (instead of at the beginning of the
tape), press C.MEMORY so that the "M" mark appears before
pressing REW.
Search Search
REW FF
5 seconds 10 minutes 5 seconds
on counter
pg. 22.
within 2 seconds.
Remote A/B Code Switching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control's A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
REW
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
REMOVE POWER SUPPLY
1
Unplug the mains power cord from the mains outlet.
SET A/B CODE SWITCH
2
Set to B.
RE-SUPPLY POWER
3
Plug the mains power cord back into the mains outlet.
TURN THE RECORDER ON
4
Press
only respond to B code signals.
NOTE:
Some TV sets may malfunction in response to the B mode. If
this happens, switch back to the A mode.
Counter Memory
Returns to the counter reading of "0:00:00" to conveniently find
a specific place on the tape automatically.
SET COUNTER MEMORY
1
Press C. RESET during playback at a point you wish to
locate later. The counter reads "0:00:00". Then press
C.MEMORY, and "M" appears in front of the counter
digits.
ACTIVATE COUNTER
MEMORY
2
When you wish to return to the designated point, press
STOP and then REW or FF.
The tape rewinds or fast-forwards and stops at about
0:00:00 automatically.
To cancel Counter Memory, press C.MEMORY again.
on the remote control. The recorder will now
19
EN