Placing Originals In The Auto Document Feeder (Adf) - Toshiba e-studio 900 Operator's Manual

Placing Originals

Placing Originals in the Auto Document Feeder (ADF)

Settings should be made in the following situations:
1
When placing originals of more than 100 pages:
See p.15 "Batch mode".
When placing originals one by one:
See p.16 "SADF mode".
When copying originals of various sizes:
See p.16 "Mixed size mode".
When copying originals onto thin paper
See p.17 "Thin mode".
When placing custom size originals:
See p.18 "Placing custom size originals".
Important
If you turn on the machine with an original left on the exposure glass and
started copying while placing originals in the ADF, a paper jam will occur.
Before turning the machine on, check there is no original left on the exposure
glass.
Note
Do not stack originals over the limit mark on the inner side wall of the ADF.
The last page should be on the bottom.
To copy thin originals of 40 to 52 g/m
may be fed at a time, and be damaged. To avoid this, place originals one by
one in the ADF, or place an original on the exposure glass.
A
Set the document guide to the original size.
B
Align the edges of the original and place it in the ADF with the side to be
copied facing up.
1.
Limit mark
2.
Document guide
14
2
(35 to 45 kg), two or more originals
TJAH050E