Grandstream Networks BudgeTone-200 User Manual page 15

Artikel 401102 aus Shop: http://www.netzwerk-online.de
#XX or #X are also valid so leading 0 is not required (but OK).
eg.
192.168.0.2 calling 192.168.0.3 just dial #3 follow by SEND or #
192.168.0.2 calling 192.168.0.23 just dial #23 follow by SEND or #
192.168.0.2 calling 192.168.0.123 just dial #123 follow by SEND or #
192.168.0.2 dial #3 and #03 and #003 has same effect --> call 192.168.0.3
Note:- If you have a SIP Server configured, Direct IP-IP call will still work. However, if you are using
STUN, Direct IP-IP call will also use STUN.
OR
To make a direct IP to IP call, first off hook, then press "MENU" key, then enter a 12-digit target IP
address to make the call. If port is not default 5060, destination ports can be specified by using "*4"
(encoding for ":") followed by the port number.
Examples:
If the target IP address is 192.168.0.10, the dialing convention is
N
MENU_key 192 168 000 010
followed by pressing the "SEND" key or wait for seconds in the No Key Entry Timeout.
If the target IP address/port is 192.168.1.20:5062, then the dialing convention would be:
N
MENU_key 192168001020*45062
followed by pressing the "SEND" key wait for seconds in the No Key Entry Timeout.
Quick IP Call Mode
The BT also supports Quick IP call mode. This enables the phone to make direct IP-calls, using only the
last few digits (last octet) of the target phone's IP-number.
This is possible only if both phones are in under the same LAN/VPN. This simulates a PBX function using
the CMSA/CD without a SIP server. Controlled static IP usage is recommended.
Setting up the phone to make Quick IP calls
To enable Quick IP calls, the phone has to be setup first. This is done through the web-setup function. In
the "Advanced Settings" page, set the "Use Quick IP-call mode to YES. When #xxx is dialed, where x is
0-9 and xxx <=255, a direct IP call to aaa.bbb.ccc.XXX is completed. "aaa.bbb.ccc" is from the local IP
address regardless of subnet mask. The numbers #xx or #x are also valid. The leading 0 is not required
(but OK).
For example:
192.168.0.2 calling 192.168.0.3 -- dial #3 follow by SEND or #
192.168.0.2 calling 192.168.0.23 -- dial #23 follow by SEND or #
192.168.0.2 calling 192.168.0.123 -- dial #123 follow by SEND or #
192.168.0.2: dial #3 and #03 and #003 results in the same call -- call 192.168.0.3
NOTE: If you have a SIP Server configured, a Direct IP-IP still works. If you are using STUN, the Direct
IP-IP call will also use STUN. Configure the "Use Random Port" to "NO" when completing Direct IP calls.
Grandstream Networks, Inc. BT200/201 User Manual
Firmware 1.2.2.19
Page 15 of 33
Last Updated: 12/2009