Termination Requirements; Installation (Continued) - Travis Industries 564 Installation Manual

3 2

Termination Requirements

N O T E : Measure all clearances from the nearest edge of the exhaust hood.
A Minimum 9" clearance from any door or window
B Minimum 12" above any grade, veranda, porch, deck or balcony
C Minimum 0" from outside corner walls
D Minimum 0" from inside corner walls
E Minimum 11" clearance below unventilated soffits or roof surfaces
Minimum 18" clearance below ventilated soffits
Minimum 6" clearance below roof eaves
NOTE: Vinyl surfaces require 24"
F Minimum 18" clearance below a veranda, porch, deck or balcony (must have two open sides)
G Minimum 48" clearance from any adjacent building
H Minimum 84" clearance above any grade when adjacent to public walkways or driveways
NOTE: may not be used over a walkway or driveway shared by an adjacent building
I Minimum 48" clearance from any mechanical air supply inlet
J Minimum 36" clearance above and 48" below and to the sides of non-mechanical air supply inlet
K Minimum 36" from the area above the meter/regulator (vent outlet)
L Minimum 36" from the meter/regulator (vent outlet)
M Minimum 24" above the roof line (for vertical terminations)
N Minimum 24" horizontal clearance to any surface (such as an exterior wall) – for vertical
terminations
G
NOTE: Measure clearances to the nearest edge of the exhaust hood.
•
Use the vinyl siding standoff (#950) when installing on an exterior with vinyl siding.
•
Vent termination must not be located where it will become plugged by snow or other material.
•
Venting termination shall not be recessed into a wall or siding.
•
These clearances meet UMC-1994 code standards.
•
These clearances meet UMC-1994 code standards.
Travis Industries
Installation
E
N
A
F
D
(for qualified installers only)
M
E
K
I
C
L
B
4 0 7 0 6 2 0
Roof
Surface
11" Min.
6" Min.
E
A
J
H
100-01188_000
Roof
Eaves