Wall Switch Or Thermostat Installation; Wiring Diagram (Millivolt System); Wall Switch Installation - Travis Industries 564 Installation Manual

Wall Switch or Thermostat Installation

Wiring Diagram (Millivolt System)

Do not connect 110-120 VAC to the gas control valve or wiring system of this fireplace. The switch must
be installed by a qualified installer.
The included wall switch may be installed following the directions below. An optional thermostat may also
be installed. It is attached to the gas control valve in the same manner.
Caution : Label all wires prior to disconnection when servicing controls. Wiring errors can cause
improper and dangerous operation.
On/Off Switch (on fireplace)
Red

Wall Switch Installation

1. Attach the included wire to the gas control valve.
Attach the two wires to the top and
bottom posts on the gas control
valve (orientation does not matter).
2. Determine a location for the wall switch (the wire is a maximum 25' long). Route the wire through the gas
inlet hole (either side) to the junction box and attach following the directions below. Set the on/off
switch on the appliance to "OFF" to control the appliance with the wall switch.
Insert the wire
a
through the back of
the mounted
junction box (your
junction box may
look different).
Expose 1/2" of
each wire. Secure
the wires to the
posts on the side of
the on/off switch
(orientation does
not matter).
© Travis Industries
Installation
Brown
Copper Co-Axial
From
Appliance
Standard
Screwdriver
(for qualified installers only)
Thermocouple Thermopile
Wire
Red
White
Optional Wall Switch,
Thermostat, or
Remote Control
Carefully pack the wires into the
b
junction box. Attach the switch
to the junction box. Attach the
switchplate to the switch.
Standard
Screwdriver
4 0 7 0 6 2 0
2 1
Piezo Igniter
Orange
Spark Electrode
Pilot Hood
100-01188_000