2.7.4 Caller ID Card (KX-TD193)
• This card is installed on the ELCOT card.
Connection to the ELCOT card (KX-TD50180)
Before connecting the Caller ID card (KX-TD193) to the ELCOT card (KX-TD50180), please
replace the spacers on the Caller ID card with the short type spacers included in the package.
Removing the spacers [Fig.-a]
Push up a spacer (See step 2.) while holding it with fingers (See step 1.) as shown in the figure
below.
Adding the short type spacers [Fig.-b]
Pull the spacer until "CLICK" sounds as shown in the figure below.
1.
Insert the connector (plug) on the Caller ID card into the connector (jack) on the ELCOT
card.
2.
Install the ELCOT card into a free slot. Please refer to Section "2.5.5 ELCOT Card (KX-
TD50180)."
Installation Manual
connector
(8-pin)
"CID" is marked.
connector
(22-pin)
Connected to
Connected to
ELCOT ports 5-8.
ELCOT ports 1-4.
Caller ID Card
Caller ID Card
ELCOT Card
[Fig.- a]
[Fig.- b]
To Remove
To Add
2
1
4-pin connector
(plug)
8-pin connector
(plug)
22-pin connector
(plug)
22-pin connector
(jack)
4-pin connector
(jack)
8-pin connector
(jack)
Installation
155