Traffic Information - Panasonic KX-TD500 Installation Manual

Utility

4.3 Traffic Information

4.3.1 Traffic Information
You can display the traffic information on your Maintenance Console PC by downloading the
traffic data measured at KX-TD500 System.
Traffic Menu consists of the following seven submenus.
• 4.3.2 Station
• 4.3.3 Trunk Group
• 4.3.4 Operator
• 4.3.5 UCD (Uniform Call Distribution)
• 4.3.6 OGM
• 4.3.7 AGC
• 4.3.8 Incoming Group
If you select "Traffic Information" in the "Utility" drop-down menu, "Traffic Measurement"
screen is displayed. The current status of traffic measurement is displayed on the top of this
screen. There are "Start," "Stop" and "View" buttons, which control measurement, depending
on under the condition of traffic measurement. The details of each item are as follows.
Traffic Measurement Status
• Now Idling
• Now measuring
Start Traffic Measurement
• "Start" button
Interrupt Traffic Measurement
• "Stop" button
View Traffic Data
• "View" button
240
The system is not in the measurement mode at present.
The system is in the measurement mode now.
The traffic measurement begins.
This button is available only when the Traffic
Measurement is idle.
The traffic measurement stops.
This button is available only when the system is
measuring the traffic.
"Traffic Information" screen is displayed.
Installation Manual