Caller Id Card (Kx-Td193) - Panasonic KX-TD500 Installation Manual

2.7 Other Cards

2.7.3 Caller ID Card (KX-TD193)

This card is installed on the ELCOT card.
Caller ID Card
Connection to the ELCOT card (KX-TD50180)
Before connecting the Caller ID card (KX-TD193) to the ELCOT card (KX-TD50180), please
replace the spacers on the KX-TD193 with the short type spacers included in the package.
Removing the spacers[Fig.-a]
Push up a spacer ( See step 2 .) while holding it with fingers (See step 1 .) as shown in the figure
below.
Adding the short type spacers[Fig.-b]
Pull the spacer until "CLICK" sounds as shown in the figure below.
1.
Insert the connector (plug) on the Caller ID card into the connector (jack) on the ELCOT
card.
2.
Install the ELCOT card into a free slot. See 2.5.11 ELCOT Card (KX-TD50180).
Note
• Four CO lines are available for the Caller ID function with one Caller ID card.
158
connector
(8-pin)
connector
(22-pin)
Connected to
ELCOT ports 5-8.
Caller ID Card
ELCOT Card
Connected to
ELCOT ports 1-4.
Caller ID Card
[Fig.- a] [Fig.- b]
To Remove To Add
2
1
4-pin connector
8-pin connector
22-pin connector
(plug)
22-pin connector
(jack)
4-pin connector
8-pin connector
(plug)
(plug)
(jack)
(jack)
Installation