Figure 62: Upload Image By Ftp Option - Quasar CP-3211 User And Installation Manual

Note:
Make sure the local recording (with Micro SD/SDHC card) is activated so that
this function can be implemented. See

Send Message by FTP/E-Mail – Select whether to send an alarm message by FTP and/or
e-mail when motion is detected.

Upload Image by FTP – Select this box in order to upload an image to a designated FTP site
when motion is detected according to various parameters, as seen the figure below. Specify
the FTP address to use from the drop-down menu. Select the number of frames for the pre-
trigger and post-trigger buffers from the drop-down menu of 1-20 frames.
Check the box for Continue image upload if you wish to use this option. To specify the length
of time for the upload, click on this radial button and enter the number of seconds. To
upload during the active trigger, click on this radial button. Finally, select the number of
frames per second from the drop-down menu next to Image Frequency.

Upload Image by E-Mail – Select this box in order to assign an e-mail address and configure
various parameters, as seen in the figure below. When motion is detected, event images are
sent to one of two designated e-mail addresses. Select the number of frames for the pre-
trigger and post-trigger buffers from the drop-down menu of 1-20 frames.
Check the box for Continue image upload to use this option. To specify the length of time for
the upload, click on this radial button and enter the number of seconds. To upload during
the active trigger, click on this radial button. Finally, select the number of frames per second
from the drop-down menu next to Image Frequency.
Note:
Make sure that SMTP or FTP configuration has been completed. See
FTP for further details.

Figure 62: Upload Image by FTP Option

Figure 63: Upload Image by E-Mail Option
Configuration and Operation
Recording for further details.
Mail and
79