Figure 98: Sequence Set Screen - Quasar CP-3211 User And Installation Manual

Quasar CP-3211/CP-4221 User and Installation Guide
Note:
Before creating a sequence, you must first define at least two Preset Points.
See Preset.
To set up Sequence Line:
1. In the Sequence setting section, click Edit. The Sequence Set screen opens.
2. Select a Sequence line number from the Sequence line drop-down list.
3. Define each Preset Point for the Sequence line in the desired order:
Select the first Preset Point from the Preset Name list. Use the PrePage or NextPage
buttons to navigate between the Sequence preset numbers.
Specify the Dwell time (between 0 and 127 seconds) for the first Preset Point.
Specify the camera's Speed (between 0 and 14).
4. Repeat steps a, b, and c for up to 64 Preset Points.
5. Click Save to save your preset sequence.
To run the camera through a Sequence line:
1. From the Sequence run section, select the Sequence line from the drop-down list.
2. Click Go. The camera moves through each Preset Point sequentially as programmed.
112

Figure 98: Sequence Set Screen