Installing A A6869B Vga/Usb Pci Card In A Server; Pci I/O Slot Details - HP 9000 Integrity rp8440 Installation Manual

Figure 2-19 PCI I/O Slot Details
7. Wait for the green power LED to stop blinking and turn on solid.
8. Check for errors in the hotplugddaemon log file (default: /var/adm/hotplugd.log).
The critical resource analysis (CRA) performed while doing an attention button-initiated
add action is restrictive, and the action will not complete and will fail to protect critical
resources from being impacted.
For finer control over CRA actions, use the pdweb or the olrad command. Refer to the
Interface Card OL* Support Guide located on the Web at http://docs.hp.com, for details.
9. Replace the top cover.
10. Connect all cables to the installed PCI card.

Installing a A6869B VGA/USB PCI Card in a Server

IMPORTANT:
as HP Superdome, rx7620, or rx8620, the system firmware must be updated to a minimum
revision of 3.88.
The A6869B VGA/USB PCI card is a dual function combo card, hosting VGA and universal serial
bus (USB) controllers. Both of these devices sit behind a PCI-PCI bridge. The A6869B VGA/USB
PCI card operates at the conventional 66MHz/64 bit PCI rate and is universally keyed. All
signalling and form factors conform to the PCI Local Bus Specification 2.3. The VGA controller has
128Mbits of DDR-1 RAM for use as a frame buffer.
58 Installing the System
If you are installing the A6869B in HP servers based on the sx1000 chipset, such