General Troubleshooting - Baumatic BA140 Instruction Manual

IF
GUARANTEE PERIOD AND FINDS THAT A FAULT
HAS BEEN CAUSED BY AN ITEM ON THE ERROR
CODE LIST, WHICH COULD HAVE BEEN CLEARED BY
THE CUSTOMER. THEN YOU MAY BE LIABLE FOR
THE COST OF THE SERVICE CALL.

General troubleshooting

Water under the washing machine
o Tighten the drain pump filter.
o Check the drain and inlet hose and make sure that it is fully
tightened.
Washing machine vibrates during the spin cycle
o Check that the transport locking devices have been removed (see
installation instructions).
o Make sure that the washing machine is installed on a flat and level
floor.
o Ensure that all four feet are resting firmly on the floor, by pressing
down on each corner and making sure that the appliance is stable.
o If it is unstable then follow the "Positioning and levelling the
appliance" section.
Poor spin results
o Clean the drain pump (see "Cleaning the drain pump filter" section).
Water in the detergent dispenser
o Although there will be some water residue left in the detergent
drawer after a wash cycle has completed. If the drawer is full of
water then you may need to clean the detergent drawer.
IMPORTANT: Your appliance has an unbalance control system.
If this system detects that the washload is unevenly distributed
inside the drum. Your washing machine will try to redistribute
the load before spinning. If after several attempts it is unable
to redistribute the washload, then the appliance will either spin
at a slower speed or skip the spin cycle and drain.
Uneven load distribution can be caused by too large a wash
load or too small a wash load. It can also occur if a single item
if washed inside the appliance.
AN ENGINEER ATTENDS DURING THE
27