General Troubleshooting - Baumatic BWM5001 Instruction Manual

General troubleshooting

Problem
o When the machine
starts from the
RINSE function, the
washing machine
does not add water.
o The wash process
changes from SPIN
to RINSE.
o The control panel is
not responding
during a program.
o There is a SPIN
delay.
o The first time the
machine is used,
there is some water
flowing out the
drainage pipe.
o Machine is
completely
unresponsive.
Possible solution
o The washing machine will start from
the SPIN process in order to spin
out the water and detergent from
the clothes, then input the water (if
there is water in the tub it will drain
out the water first).
o When the clothes are not even
inside the tub, the washing machine
will input the water and make the
clothes balanced and even.
o If you want to change the cycle
after the washing machine has
started, press the pause button and
then change the program.
o Check that the safety lock is not
activated.
o The washing machine will delay 15
to 60 seconds to enter the SPIN
process after DRAIN or after select
SPIN process only.
o This is remaining water only, which
is from the factory checking
process.
o There is a loose connection in the
power socket which needs
tightening.
o The fuse is broken. Call an
electrician to check the socket or
fuse.
o Power cut.
o Voltage is too high or low.
36