Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Baumatic BWD1409W
Summary of Contents for Baumatic BWD1409W
- Page 1 BWD1409W 60 cm 9 kg Freestanding washer dryer...
- Page 2 USER MANUAL FOR YOUR BAUMATIC BWD1409W 60 cm 9 kg Freestanding washer dryer NOTE : This User Instruction Manual contains important information, including safety & installation points, which will enable you to get the most out of your appliance. Please keep it in a safe place so that it is easily available for future reference;...
-
Page 3: Table Of Contents
Contents Environmental note Important safety information 5 – 6 Specifications 7 – 12 Description of the appliance Control panel 9 - 10 LED display Detergent drawer Preparing the wash cycle 13 - 16 Preparing your garments for washing A selection of wash care symbols Detergents and conditioners 14 - 15 Wash program table... -
Page 4: Environmental Note
Environmental note o The packaging materials that Baumatic uses are environmentally friendly and can be recycled. o Please discard all packaging material with due regard for the environment. -
Page 5: Important Safety Information
General Safety o Repairs to your appliance must only be carried out by a Baumatic engineer or one of its authorised service agents. Any attempt by an inexperienced person to repair the appliance, could result in injury or damage to your washer dryer. - Page 6 If you use either dyes or bleaching agents inside this machine, then you should consult with the manufacturer of these products to make sure they are suitable for use in your washer dryer. Baumatic cannot be held responsible for any damage that may result. Child Safety o Your washer dryer should only be used by adults.
-
Page 7: Specifications
Specifications o 18 wash programs o 5 drying programs o 9 kg wash load o 7 kg drying load o 1400 rpm maximum spin speed o LED display o Delay start o Digital condensing dry system o Digital countdown indicator o Wash phase indicator o Tilted drum o Air bubble washing system... -
Page 8: Description Of The Appliance
Description of the appliance Accessories... -
Page 9: Control Panel
Control panel 1) Power button. Press this button to turn the power on or off. 2) Start/pause button. Operation and temporary stop is repeated as it is pressed. When you want to change a program while it is in use, press this button, then select the program you want to change to, and then press this button again. - Page 10 5) Spin button. By pressing this button, the spin speed can be chosen. You can set the spin speed by rpm through the following options: Rinse Hold 1000 1400 6) Wash button. You can select the cycle you want by using this button.
-
Page 11: Led Display
LED display Wash cycle progress indicator This lights when a wash cycle is in progress, to indicate what stage of the wash cycle the appliance has reached from: Wash Rinse Spin Wash display This lights the wash functions that have been selected such as a pre- wash or a soak. -
Page 12: Detergent Drawer
Detergent drawer Main wash section This compartment should have detergent placed in it (you should also put a water softening agent in this section, if you use one). The detergent will be added to the drum at the start of the main wash program. -
Page 13: Preparing The Wash Cycle
Preparing the wash cycle Preparing your garments for washing o Your washing should be sorted out, according to the fabric type and the wash care symbol that is printed on the garment’s wash care label (see separate section on wash care symbols). o Your washing should also be sorted out according to the degree of soiling. -
Page 14: A Selection Of Wash Care Symbols
A selection of wash care symbols Washing Normal Normal Boiling Do not Wool Do not Bleachable temp temp temp bleach! seal wash! in cold 60°C 40°C 95°C water cleaning Hand Benzine All but TRI Do not Delicate Delicate wash only clean! temp temp... -
Page 15: Wash Program Table
detergent manufacturer and placed inside the drum. All instructions on the detergent packaging should be followed. Water softening agents If your tap water is hard, then it may be prudent to utilise a water softening agent. This will help to ensure that the appliance does not become clogged with hard water deposits. -
Page 16: Wash Program Guidance
Water+: This will add an extra 6 litres of water to the rinse section of any cycle to increase the rinse performance without lengthening the cycle time. Wash program guidance o A wash program option can only be selected if the program table advises that it is possible with the wash cycle you have selected. -
Page 17: Selecting A Wash Program
Selecting a wash program Cotton program o Put the laundry into the drum and then close the door. The maximum load size is 9kg for a cotton wash. o In the detergent drawer, put detergent into the main wash and pre-wash compartments. - Page 18 Synthetic program o Put the laundry into the drum and then close the door. The maximum wash load size is below 3kg for the synthetic program. o In the detergent drawer, put detergent into the main wash and pre-wash compartments. o Put detergent into the pre wash compartment only if you want to use the pre-wash option.
- Page 19 Delicate/ handwash program o Put the laundry into the drum and then close the door. The maximum wash load size is below 3kg for the delicate program. o In the detergent drawer, put detergent into the main wash compartment. o Softener should be poured into the middle compartment of the detergent drawer;...
- Page 20 Intensive program o Put the laundry into the drum and then close the door. o Put detergent into the main wash and pre-wash compartments in the detergent drawer. Softener should be below the ‘MAX’ level. o Put detergent into the pre-wash compartment only if you want to add pre-wash.
- Page 21 o Use the wash program selection knob (3) to select the Quick 20 program. o A wash temperature of ‘cold’, with an 800 rpm spin will be selected automatically by the appliance. o Press the start/pause button (2), the door will lock and after a few seconds you will hear the machine start to fill with water.
- Page 22 o Press the start/pause button (2), the door will lock and after a few seconds you will hear the machine start to spin. Only wash o Put the laundry into the drum and put detergent and softener into the detergent drawer. Then close the door. o Press the power button (1) and the LED will show only “---“.
-
Page 23: End Of Cycle
o Press the start/pause button (2) and the machine will begin the cycle after a few seconds. o For approximate drying times for each cycle, see the table below: Drying Cycle Approximate Time (hr.min) Time set 01.00 – 04.00 Low temperature 01.40 Iron 01.30... -
Page 24: Delay Start Feature
o IMPORTANT: Changing the wash program will cancel any spin or temperature alterations that you have made and any program options that you have selected. You will need to make the spin/ temperature alterations again and re-select any program options that you require. -
Page 25: Child Lock
Child lock Your appliance has a child lock option, if this is set, it will mean that nobody can affect the operation of the wash program once it has started. o To activate the child-lock, press and hold the wash button (6) and the temperature button (4) at the same time for approximately three seconds. -
Page 26: The Washer Dryer Drum
o Wash the detergent drawer in warm, soapy water. For ease of cleaning, you can remove the upper part of the fabric softener compartment. o Detergent can also accumulate inside the detergent drawer recess, so you should also clean this out using a brush o Once you have finished cleaning the detergent drawer and recess, you should slide the drawer back... -
Page 27: Cleaning The Drain Pump Filter
o At the end of the wash cycle, you should leave the porthole door open for a short period of time. Cleaning the drain pump filter IMPORTANT: Switch off your washer dryer and disconnect the plug from your mains supply. You should clean out the filter approximately every ten washes. -
Page 28: Cleaning The Water Inlet Filter
IMPORTANT: If you are draining water from the bail hose and drain pump filter in an emergency. You should take care as the water coming from the machine mid-cycle could be hot. Especially if the water is being drained in the middle of one of the hotter wash cycles. Cleaning the water inlet filter o Clean the filter when water leaks from the water inlet. -
Page 29: Stain Removal Rules
Stain removal rules o Use warm water for soaking or pre-washing stained laundry. Hot water can set stains. o Most stains are easier to remove when they are fresh. o Before treating any stain try to establish; what kind of stain it is, how old the stain is, what the fabric type is and whether the fabric is colourfast (check the care label to find this out). - Page 30 cloth, a mixture of 1 unit alcohol, 2 units water should be used). Blood stain Lay your clothes in cold water for 30 minutes. If the stain still does not disappear, lay in mixture of water and ammonia (3 table-spoons of ammonia in 4 litres of water) for 30 minutes.
-
Page 31: Poor Wash Results
Poor wash results My garments are looking grey and there are limescale deposits present in the drum of my washer dryer. o There is not enough detergent being added. o The incorrect detergent is being used. o Stains are not being pre-treated. o The correct wash program or wash temperature was not selected. -
Page 32: Installation
Installation IMPORTANT: THIS INSTALLATION MUST COMPLETED BY A SUITABLY QUALIFIED PERSON. BAUMATIC ONLY SANCTION INSTALLATION GIVEN THIS INSTRUCTION MANUAL. SHOULD KEEP THE TRANSIT PACKAGING, IN CASE YOU NEED TO TRANSPORT THE MACHINE IN THE FUTURE. Removing the transit bolts IMPORTANT: Before installing or operating the washer dryer, YOU MUST remove the transit bolts that hold the drum in position whilst the appliance is being transported. -
Page 33: Locating Your Washer Dryer
Locating your washer dryer o Before commencing installation, check the location where you intend to install the appliance. You should make sure that you have everything in place that is necessary for the correct installation. o Do not place or store your washer dryer in a location where the ambient temperature could fall below 0°C, otherwise the water in it could freeze up. - Page 34 For an ordinary tap For a screw-shaped tap...
-
Page 35: Connecting To The Water Outlet
onnecting to the water outlet Secure the drain hose, so that it cannot move whilst the washer dryer is in use. Place the end of the drain hose on your drain pipe. Push it a s hort way down into your drain pipe. IMPORTANT: Do not insert the drain hose too deeply into the wate pipe, as this may cause siphoning. -
Page 36: Power Supply
IMPORTANT: There should be no instability of the machine when the adjustable legs have been set to the correct level. Power supply IMPORTANT:The electrical socket must still accessible once the appliance is installed. Consult the rating plate, located on the inner rim of the porthole door or the right hand side of the cabinet BEFORE making... -
Page 37: Before First Use Maintenance Wash
IMPORTANT: We do not recommend that this appliance is connected to an extension lead. Before first use maintenance wash o When your washer dryer been correctly installed, recommend that you perform a maintenance wash cycle, without any clothing being placed inside of the drum. o This will check that all aspects of the installation are correct;... - Page 38 You should turn the washer dryer off using the POWER button. Disconnect appliance from your mains supply. Then arrange for an engineer to attend the appliance. You should contact Baumatic Customer Care Department on (0118) 933 6911.
-
Page 39: General Troubleshooting
ENGINEER ATTENDS DURING GUARANTEE PERIOD AND FINDS THAT A FAULT HAS BEEN CAUSED BY AN ITEM ON THE ERROR CODE LIST, WHICH COULD HAVE BEEN CLEARED BY THE CUSTOMER. THEN YOU MAY BE LIABLE FOR THE COST OF THE SERVICE CALL. General troubleshooting Water under the washer dryer o Tighten the drain pump filter. - Page 40 Or any installation other than the one specified by Baumatic Ltd. has been completed. Please refer to the conditions of guarantee that appear on the warranty card that you receive with the appliance.
-
Page 41: Contact Details
United Kingdom Czech Republic Baumatic Ltd., Baumatic CR s.r.o. Baumatic Buildings, Lípová 665 6 Bennet Road, 460 01 Liberec 4 Reading, Berkshire Czech Republic RG2 0QX United Kingdom +420 483 577 200 Sales Telephone www.baumatic.cz (0118) 933 6900 Sales Fax...