General Troubleshooting - Baumatic BFWM1406W 60 cm6kg Instruction Manual

IF
GUARANTEE PERIOD AND FINDS THAT A FAULT
HAS BEEN CAUSED BY AN ITEM ON THE ERROR
CODE LIST, WHICH COULD HAVE BEEN CLEARED
BY THE CUSTOMER. THEN YOU MAY BE LIABLE
FOR THE COST OF THE SERVICE CALL.

General troubleshooting

Problem
The washing machine does
not work.
Water leakage.
The spin of the clothes is
abnormal.
There is a peculiar smell in
the washing machine.
No water is visible in the
drum.
There is remaining water
in the softener
compartment.
The remaining detergent is
left on the clothes.
The washing machine does
not fill.
Spinning starts late or the
machine does not spin.
If a fault code reappears after following the
above advice and clearing the fault code. You
should turn the
Disconnect the appliance from your mains
supply. Then arrange for an engineer to
attend the appliance. You should contact the
Baumatic Customer
(0118) 933 6911.
AN ENGINEER
Possible solutions
Close the washing machine's door.
o
Confirm and press the start button.
o
Correctly connect the inlet water pipe.
o
Reload and distribute the laundry evenly in the
o
drum.
Run a high temperature cycle without any
o
clothes.
No fault. The water is under the visible area.
o
No fault. The effect of the softener will not be
o
affected.
The water-fast component of the non-
o
phosphorus detergent left on the clothes will
cause lime scale. Select the rinse and spin
program or brush away the detergent when the
clothes are dried.
Open the water tap.
o
Check the selection of the program.
o
Check the water pressure to see if the water
o
pressure is insufficient.
Put through the feed-water.
o
Close the machine's door.
o
Check if the inlet water pipe is bent or clocked.
o
The imbalance control system has activated
o
because the laundry is unevenly distributed in
the drum,
The appliance will redistribute the laundry by
o
reversing the drum rotation. This may take
several attempts before the laundry is evenly
distributed and normal spinning can resume.
If the laundry is still not evenly distributed after
o
10 minutes, the machine will not spin. In the
event of this, redistribute the load manually and
select the program again.
washing machine
Care Department
ATTENDS DURING
off.
on
THE
34