Table of Contents
Advertisement
IF
GUARANTEE PERIOD AND FINDS THAT A FAULT
HAS BEEN CAUSED BY AN ITEM ON THE ERROR
CODE LIST, WHICH COULD HAVE BEEN CLEARED
BY THE CUSTOMER. THEN YOU MAY BE LIABLE
FOR THE COST OF THE SERVICE CALL.
General troubleshooting
Water under the washing machine
o Tighten the drain pump filter.
o Check the drain and inlet hose and make sure that they are fully
tightened.
Washing machine vibrates during the spin cycle
o Check that the transport locking devices have been removed (see
installation instructions).
o Make sure that the washing machine is installed on a flat and level
floor.
o Ensure that all four feet are resting firmly on the floor, by pressing
down on each corner and making sure that the appliance is stable.
If it is unstable then follow the "Locating your washing machine"
and "Leveling the appliance" sections.
Poor spin results
o Clean the drain pump (see "Cleaning the drain pump filter" section).
Water in the detergent drawer
o Although there will be some water residue left in the detergent
drawer after a wash cycle has completed. If the drawer is full of
water then you may need to clean the detergent drawer.
If a fault code reappears after following the
above advice and clearing the fault code. You
should turn the washing machine off using
the POWER button. Disconnect the appliance
from your mains supply. Then arrange for an
engineer to attend the appliance. You should
contact
the
Department on (0118) 933 6911.
AN
ENGINEER
Baumatic
Customer
ATTENDS
DURING
Care
THE
37
Advertisement
Table of Contents
