Driver Installation - Advantech PCM-3335 User Manual

These drivers are designed to work with Autodesk AutoCAD
R12. They conform to the Autodesk Device Interface (ADI) for
Rendering drivers and Display drivers. These display list drivers
accelerate redraw, pan, and zoom functions.
Step 1: Place the display driver diskette in drive A. Type A:
<ENTER> to make this the default drive. Type SETUP <EN-
TER> to run the SETUP program. Press any key to get to the
applications list. Using the arrow keys, select AutoCAD Release
12 and press <ENTER>. This will display a list of supported
driver resolutions. Using the arrow keys and the <ENTER> key,
select the resolutions that are appropriate for your monitor. When
all of the desired resolutions have been selected, press <END> to
begin the installation. At this point you will be asked for a drive
and directory to copy the driver files. Enter the drive and directo-
ry that contains the installed AutoCAD R12. If the destination
directory does not exist you will be asked for confirmation. When
the installation is complete, press any key to continue. Press
<ESC> followed by Y to exit to DOS.
Step 2: Go to the AutoCAD directory where the new drivers were
installed and run the driver installation program by typing
ACAD12 -r <ENTER>. This program will configure your
AutoCAD R12 to use the new display drivers. Select TurboDLD
Classic.
Select Configure Video Display. In Display Device Configura-
tion choose Select Graphics Board/Resolution. Then choose
Select Display Graphics Board. After choosing a graphics board,
go to Select Display Resolution. After selecting the display
resolution, save the new configuration, and return to the main
menu.
38 PCM-3335 User's Manual