Basic Network Settings - Alcatel Temporis IP150 Manual

Network
You can set up the phone for your network configuration on the Network settings page.
Your service provider may require you to configure your network to be compatible with
its service, and the phone settings must match the network settings.

Basic Network Settings

Note: If you disable DHCP on this page, you must configure static IP settings for the
phone. You must be familiar with TCP/IP principles and protocols to configure static IP
settings.
Basic Network Settings
Setting
Enable DHCP
network.ip.dhcp_enable
IP Address
network.ip.static_ip_addr
Subnet Mask
network.ip.subnet_mask
Gateway Address
network.ip.gateway_addr
Primary DNS Server
network.ip.dns1
Temporis IP150 Administration and Provisioning Guide
Description
DHCP is selected (enabled) by
default, which means the deskset
will get its IP address from the
network.
When DHCP is disabled, you
must enter a static IP address for
the deskset.
If DHCP is disabled, enter a
static IP address for the deskset.
Enter the subnet mask.
Enter the static IP address of the
default gateway (in this case,
your router).
If DHCP is disabled or you don't
wish to use the DHCP-assigned
Range Default
1: Enabled, 1
0: Disabled
IPv4 blank
IPv4 blank
IPv4 blank
IPv4 blank
ed 0.1 47/106