Alcatel TMAX 20 Land Line Phone Manual

Table of Contents

Contents

1 THE KEYS AND THE FEATURES
- 1.1 DISPLAY ICONS
2 INSTALLING AND REPLACING THE BATTERIES
3 INSTALLATION AND SETUP AND ITS BASE
4 USING THE PHONE
5 GENERAL SETTINGS
6 SAFETY
7 ENVIRONMENT
8 CONFORMITY
9 Documents / Resources
- 9.1 References
- 9.2 Download manual

THE KEYS AND THE FEATURES

THE KEYS AND THE FEATURES - Part 1

LCD Display
Down Key
Mem Key
Mute/New/Ringer Indicator
Delete/ Exit Key
Microphone Mute Key
Phonebook Key
Redial Key
Flash/Contrast Key
Handsfree Key
Vol Key
Menu Key
Up Key
Line Jack
Ringer Volume Switch
Battery Cover

A and B: Holes for the base

DISPLAY ICONS

Month
New CID
Day
Voice mail
Hour
Minute
Outgoing Call
Incoming Call
Call-log Number
Day Of The Week
Phone Number Display
Repeat

INSTALLING AND REPLACING THE BATTERIES

Your phone uses 3 AA-size alkaline batteries (not supplied) which are necessary to see menu in idle mode, to program, to save memories. But, it is still possible to receive and place calls without batteries or when out of use.

If you are not going to use the telephone for more than 30 days, remove the batteries because they may leak and damage the unit.

BATTERY

If the telephone line cord is connected, disconnect it from the base unit.
Carefully turn over the phone, use a pen or paper clip to loose the battery cover. Open the battery compartment by pushing on the battery cover and sliding it away from the unit.
Insert 3 AA-size alkaline batteries (not included) as shown on the diagram in the battery compartment.
Snap the battery compartment door back into place.
If the line cord was previously connected, reattach it to the unit.

INSTALLATION AND SETUP AND ITS BASE

Connecting the handset.
Connecting the telephone line and turns it towards the top part of the telephone.
Install the telephone foot: its curve part towards the bottom side, insert it in the 2 A recess, place the line cord through small hole. Then, press to place the foot inside recess B.

SET FLASH TIME TO OPERATE CORRECTLY ON YOUR NETWORK

Press MENU key / or select SET 6 FLASH / MENU / or to select flash time 110 / 300 / 600 or 1000 / MENU/ .

USING THE PHONE

RECEIVE AND END A CALL

/
/ /
/
/ / /
To increase hearing volume during conversation, press.

MAKE A CALL

or either before or after dialing your number
From redial list:
/ or
From call log list*:
or to select the caller number / or
From direct memories:

MEM or + / or
or / MEM or +

LCD CONTRAST ADJUSTMENT

In on-hook state, user can press the / button to select the LCD Contrast (1~5 choice)

REVIEW CALLER ID NUMBER

* Subject to subscription and availability of the service froPWKH¿[ed line operator.

DELETE CALLER ID NUMBER

Delete a Caller ID number: or to select the number /
Delete all Caller ID number: or to select the number / Press key for 3 seconds to delete all Caller ID number.

STORE NUMBER

Store a telephone number: to input number / MENU / to select memory location, or MEM.
Store an incoming call number: or to select the number /MENU / to select memory location, or MEM.
Store an outgoing number: Press to select the number /MENU / to select memory location, or MEM.

REVIEW AND DIAL BACK AN OUTGOING NUMBER

Review an outgoing number: Press .
Dial back an outgoing number: Press / or .

DELETE AN OUTGOING NUMBER

Delete an outgoing number: Press /
Delete all outgoing number: Press / Press key for 3 seconds to delete all outgoing number.

GENERAL SETTINGS

SETTING DATE AND TIME

Press MENU key / or select SET 1 DATE / MENU / or to enter Year, Month, Day, Hour and Minute / MENU / .
Press as many times as needed on to reach the number desired.
Press MENU to save. Press again MENU to reach the next step.

SETTING ALARM

Press MENU key / or select SET 5 ALERT / MENU / use or key to set time and select ON or OFF / MENU / .

SETTING TONE/PULSE

Long press * button ( >3s ).

SAFETY

Do not use your telephone to norify a gas leak or other potential explosion hazard. Do not open your device to avoid risk of electrical shock. Your telephone must be located in a dry place away from hot, humide and direct sunlight condition.

ENVIRONMENT

This symbol means that your inoperative electronic appliance must be collected separately and not mixed with the household waste.
Help us to protect the environment in which we live!

CONFORMITY

The logo printed on the products indicates the conformity with all essential requirements and all applicable directives. You can download the Declaration of Conformity from our website www.alcatel-home.com