Table of Contents
Advertisement
ZN‐PTZ(W)xxVPIPE4100/IPE4500 Installation Guide
① LAN Connector (Ethernet)
This is a RJ45 LAN connector for 10/100 Base‐T Ethernet.
LED1 LED2
This LED lights up as orange and turns green when the encoder is powered on.
LED operation setting:
For the factory default setting, LED 2 blinks for the heartbeat and LED 1 turns on for video signal. To
change its setting, refer to the section 4.5.11. LED Setting of the NVC Web Page User's Manual.
② RS‐485
The camera supports RS‐485 Serial Communication Port.
③ 3 pin connector for power
The camera needs an AC24V for power supply. Refer to the section "5.1.Connectors" for more specific
information.
④ External video
It is an analog video output port.
⑤ 5 pin connector for D/O
The camera provides 2 channel D/O. Refer to the section "5.1.Connectors" for more specific
information.
⑥ 6 pin connector for D/I
The camera provides 4 channel D/I. Refer to the section "5.1.Connectors" for more specific information.
⑦ Audio Output
The camera has a mono audio output.
⑧ Audio Input
The camera has a mono audio input.
⑨ Reset
Reset switch is used for restarting or resetting the camera as Factory Default (FD). Refer to the section
"6.3. Reset" for more specific information.
06A.02
10
Advertisement
Table of Contents
