IDTECK Star 505R Quick Installation Manual page 5

※
505R/IP505R/SR505 QUICK INSTALLATION GUIDE
3.2 The Back of Panel
○ Initialization Switch
1
Button
Initialization Switch
○
1
This switch is used to initialize Star 505R. For initialization, press down this switch and then keep it more than 2
seconds. Refer to „8.2 System Initialization‟ of the main manual for more details.
Communication Display LED
○
2
# 3, 4(yellow, green) LED will twinkle during RS232, RS422 and TCP/IP communication.
If the LAN is connected normally during TCP/IP communication, green LED will turn on. But in the
collision status, the #2 LED (red) turns on.
Figure: Magnification of the Communication Display LED in the Rear Panel
Tamper Switch
○
3
If someone takes off installed Star 505R on the wall by force, this tamper switch is activated then buzzer makes
sound.
○ Communication Display LED
2
Figure: Star 505R Rear Panel
5
○ Tamper Switch
3
1 2 3 4