Digital Watchdog SNAP-IT DWC-V4363D Manual page 57

EXPOSURE
BRIGHTNESS 0 ~ 99
SHUTTER 1/60 / 1/100 / FLC / 1/250 ~ 100000 / SENS-UP x2 ~ x256
BLC OFF / ON
BLC (Back Light Compensation)
AGC HIGH / MIDDLE / LOW / OFF
AGC (AUTO GAIN CONTROL)
MAX_DR OFF / ON (0~20) (Electronic Wide Dynamic Range)
STARLIGHT AUTO (x2 ~ x256) / OFF (x32 is recommended for low light application.)
EXIT JUMP
EXIT / SAVE&EXIT / FACTORY RESET
COLOR
WB MODE AWC / ATW / MANUAL (AWC is recommended.)
R-Y GAIN 0 ~ 255
B-Y GAIN 0 ~ 255
EXIT JUMP EXIT / SAVE&EXIT / FACTORY RESET
DAY & NIGHT
AUTO / COLOR / BW / EX-CONT
Day & Night Mode
COLOR ▬►BW : Switching from COLOR to BW; If the number is higher, the camera will only switch during a super low light condition.
BW ▬►COLOR : Switching from BW to COLOR; This number should be always lower than COLOR to BW
Read Time : time interval to switch from COLOR to BW
COLOR
B&W : (BURST : OFF/ON) When the burst is OFF, the picture will have less noise.
C_SUP
Color Suppression : Color will be reduced at low illumination, if the C_SUP Level is higher.
0 ~ 100 (not available when 3D-DNR is on)
A_SUP
Aperture Suppression : Edge sharpness will be reduced at low illumination, if A_SUP Level is higher.
0 ~ 100 (not available when 3D-DNR is on)
EXIT JUMP EXIT / SAVE&EXIT / FACTORY SET
57