Digital Watchdog SNAP-IT DWC-V4363D Manual page 51

EXPOSURE
BRIGHTNESS 0 ~ 100
SHUTTER 1/60 / FLK / 1/250 ~ 10000 / SENS-UP x2 ~ x256
BLC/HME OFF / BLC / HME
HIGH / MIDDLE / LOW / OFF
AGC
AGC(Auto Gain Control)
STARLIGHT AUTO(x2 ~ x256) / OFF
NIGHT-UP NORMAL / HIGH
EXIT JUMP
EXIT / SAVE&EXIT / FACTORY SET
COLOR
AWC / AWT / PUSH LOCK / MANUAL / INDOOR / OUTDOOR
WB MODE
R-Y GAIN 0 ~ 100
B-Y GAIN 0 ~ 100
EXIT JUMP EXIT / SAVE&EXIT / FACTORY SET
DAY & NIGHT
AUTO : READ TIME(3~63) / S-LEVEL(0~100) / E-LEVEL(0~100)
Day & Night Mode
COLOR ▬► B&W : Switching from COLOR to BW; If the number is higher, the camera will only switch during a super low light condition
B&W ▬► COLOR : Switching from BW to COLOR; This number should be always lower than COLOR to BW
Read Time : time interval to switch from COLOR to BW
COLOR
B&W Mode : BURST (OFF / ON) There is less noise when the BURST is OFF.
C_SUP Color Suppression : Color will be reduced at low illumination, if the C-SUP Level is set higher.
0 ~ 63
A_SUP
Aperture Suppression : The sharpness of the edges will be reduced at low illumination, if A-SUP level is set higher.
0 ~ 15
EXIT JUMP EXIT / SAVE&EXIT / FACTORY SET
SMART IR (OFF / ON)
51