FLIR Voyager II Installation Manual page 7

Step 3:
Remove the grommet seal from the cable
gland by inserting a fi nger and pulling it out.
Step 4:
Now that the grommet cap (A), seal (B),
and cable gland (C) have been disassembled,
remove the other sections of the grommet
from the front of
including the 1" reducer (D), and the inner lock
nut (E).
Step 5:
Now prepare the main cable ends for attach-
ment to the inside of the Bulkhead Box. As
directed by the drawing supplied in this Instal-
lation Manual, measure 13.5" from the end of
the cable, carefully cut around the outer black
cable jacket until you can slide it off, and re-
move it. Be careful not to cut into the metal
braid beneath the outer jacket.
Step 6:
Slide the black outer jacket off the cable,
exposing the inner metal braid
the Breakout Box,
A B
7
C D E