FLIR Voyager II Installation Manual page 8

Step 7:
Push the braid back over the black outer jack-
et an inch or two, creating an area of slack in
the braid. Carefully insert scissor tips into the
braid, and cut all the way around it as shown.
Slide the excess braid off the cable and dis-
card it
Step 8:
Working with the shorter length of braid, trim
it so that only 1" extends beyond the black out-
er jacket as shown.
Step 9:
Slide the grommet cap (A – not shown), seal
(B), and cable gland (C) over the cable
A
B
C
Step 10:
Slide the grommet seal up the cable so that
the front edge just lines up with the end of the
black outer cable jacket as shown
8