FLIR Voyager II Installation Manual page 11

Step 18:
Slide the outer insulation off, and separate the
two inner wires as shown
Step 19:
Strip ¼" from the end of each wire as shown.
When this is done, they are ready for termina-
tion in the Bulkhead Box.
Step 20:
Slide all of the prepared wires and the video
cable through the 1" reducer. Then carefully
pass all of the prepared wires and the video
cable through the hole in the front of the Bulk-
head Box.
Step 21:
Slide all of the prepared wires and the video
cable through the lock nut, and secure it to
the 1" reducer as shown
11