FLIR Voyager II Installation Manual page 10

Step 15:
Trim the clear Mylar sheath back so the in-
dividual wire bundles can be spread apart
as shown. This will make them easier to
identify and work with.
Cut the blue Ethernet cable to 12.5" long, mea-
sured from the end of the cable gland.
Cut the wire bundle inside a clear jacket and
steel braid to measure 11.5" long.
Cut the bundle of 4 twisted pairs inside a white
outer jacket to measure 11.5" long.
The video cable should be cut to 9.5"
Step 16:
Prepare the video cable by securing the crim-
pable 75-ohm BNC connector (provided) onto
the RG-179 cable.
Step 17:
The rest of the wires will need to be
prepared in a fashion similar to the following
progression.
Carefully cut around the outer insulation as
shown.
10