Table of Contents
Advertisement
NOTE:
Since DHCP is not supported over IPoA, users must manually enter the IP
address or WAN interface for the default gateway and the DNS server
addresses (primary and secondary), as provided by their ISP.
Step 4: Click Next. The following screen appears.
Enable NAT
If the LAN is configured with a private IP address, the user should select this
checkbox. The NAT submenu will display after the next reboot. The user can then
configure NAT-related features. If a private IP address is not used on the LAN side,
this checkbox should not be selected so as to free up system resources.
Enable Firewall
If the firewall checkbox is selected, the Security submenu will display after the next
reboot. The user can then configure firewall features. If the firewall is not used, this
checkbox should not be selected so as to free up system resources.
Enable IGMP Multicast (Proxy): Tick the checkbox to enable IGMP multicast.
IGMP (Internet Group Membership Protocol) is a protocol used by IP hosts to report
their multicast group memberships to any immediately neighboring multicast
routers.
Enable WAN Service: Tick the checkbox to enable WAN service.
Service Name: This is the WAN Service label.
STEP 5: Click Next to display the WAN Setup - Summary screen that presents the
entire configuration summary. Click Back to modify the settings.
26
Advertisement
Table of Contents
