Table of Contents
Advertisement
NOTE:
The Save button saves new settings to allow continued configuration
while the Save/Reboot button not only saves new settings but also
reboots the device to apply the new configuration (i.e. all new settings).
3.1.3 Setup Access control
The Access Control option under the Management menu bar configures access
related parameters in three areas: Services, IP Addresses, and Passwords. Use
Access Control to control local and remote management settings for the device.
Services
The Services option limits or opens the access services over the LAN or WAN. These
access services are available: FTP, HTTP, ICMP, SNMP, SSH, TELNET and TFTP.
Enable a service by ticking its checkbox. Click Save/Apply to activate.
NOTE:
The WAN column is present if the WAN interface is active. Only the LAN
side will be displayed if the WAN interface is down.
IP Addresses
The IP Addresses option limits local access by IP address. When the Access
11
Advertisement
Table of Contents
