Call Hold - Panasonic KX-TDA50G Feature Manual

3.1.2 Call Hold

•
Even if the caller's name is sent, the name may not be shown depending on the type of SLT.
•
Incoming Call Log information is not shown on the SLT
•
Caller ID shows whether the call is an intercom or CO line call by default. This setting can be disabled
through system programming.
•
A caller ID name received from the network via a PRI23 card will not be displayed on an SLT. However, if
the received caller ID matches a System Speed Dialing entry, and a name is registered for that entry, it
will be displayed.
PC Programming Manual References
4.4 [2-3] Timers & Counters—Miscellaneous
→ Caller ID—Waiting to receive
→ Caller ID—Visual Caller ID Display
4.17 [2-9] System Options—Option 4—
Public Caller ID Digits
4.18 [2-10] Extension CID Settings
5.1 [3-1-1] Trunk Group—TRG Settings—Main—
6.1 [4-1-1] Wired Extension—Extension Settings—Option 8
→ Extension Caller ID
→ Incoming Call Wait Timer for Extension Caller ID
8.1 [6-1] System Speed Dial
5.3 [3-1-3] Caller ID Modification
PT Programming Manual References
[001] System Speed Dialing Number
[002] System Speed Dialing Name
[490] Caller ID Signal Type
Feature Manual References
16.1.1 SMDR (Station Message Detail Recording)
16.1.3 Speed Dialing, Personal
16.1.4 Speed Dialing, System
3.1.2 Call Hold
Description
An extension user can put a call on hold. The following Hold features are available:
Feature
Regular Hold
Exclusive Call Hold
The result of the holding operation can be determined through system programming. Pressing the HOLD button
again just after the first time alternates the mode between Regular and Exclusive Call Hold.
36 Feature Manual
Private Network—Public Call through Private Network—Minimum
Caller ID Modification Table
Any extension can retrieve a held call.
Only the extension user who held the call can retrieve it.
Description
Document Version 2008-11