Panasonic KX-TDA50G Feature Manual page 74

4.1.6 DIL (Direct In Line)
[Method Flowchart]
Yes
The call is routed to its
CLI destination.
[Programming Example: DIL Table]
The table can be programmed for each CO line.
Port No.
(CO Line No.)
Day
01 Enable
02 Enable
*1
® 12.2 [10-2] DIL Table & Port Settings—DIL—
® [450] DIL 1:1 Destination
In this example:
If a CO line call is received on CO line 01:
In day mode: Calling Line Identification (CLI) distribution is enabled. The call is routed to its CLI destination, if
assigned. If not assigned, the call is routed to the Direct In Line (DIL) destination, extension 101.
In lunch mode: CLI distribution is disabled. The call is routed to the DIL destination, extension 100.
Note
Tenant numbers and VM trunk group numbers (not shown here) can also be programmed in the DIL
Table.
The tenant number programmed here is used only to determine the Time Table used by each CO line;
selecting tenant 3 means the CO line will use Time Table 3, for example. The VM trunk group number set
74 Feature Manual
A CO line call is received.
Does the call have
Caller ID information and is CLI
distribution enabled for the CO line in
the current time mode?
Yes
Has the caller
been stored in the System Speed
Dialing Table and has a CLI destination
been assigned?
No
Is a DIL destination assigned
for the current time mode?
Yes
The call is routed to the
DIL destination.
CLI Distribution
Lunch Break Night
Disable Enable Disable
Disable Disable Disable
DIL Destination—Day, Lunch, Break, Night
No
No
The call is routed to an
operator (Intercept
Routing—No Destination).
DIL Destination
*1
Day Lunch Break
101 100 101
102 100 102
Night
100
100
Document Version 2008-11