Table of Contents
Advertisement
Connections
Connecting the satellite (front, center, surround)
speakers
Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.
Powered subwoofer
Front speakers
SP-THM508F
4 m
Speaker (rear side)
Base plate
CAUTION
• When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.
• DO NOT connect more than one speaker to one speaker terminal.
9
SP-PWM508
Top of the base plate
FRONT
Screw M4 x 20 mm
(supplied)
Speaker cord (supplied)
• Connect the silver cords to the black (r) terminals.
• Connect the copper cords to the (q) terminals referring to
the table below:
FRONT SPEAKERS (RIGHT)
FRONT SPEAKERS (LEFT)
CENTER SPEAKER
SURROUND SPEAKERS (RIGHT) Gray
SURROUND SPEAKERS (LEFT)
4 m
Center speaker
SP-THM508C
Copper
Silver
Red
Black
• When installing the satellite speakers on the wall;
Be sure to have them installed on the wall by a qualified personnel.
•
DO NOT install the satellite speakers on the wall by yourself to
avoid unexpected damage from their falling off the wall due to
incorrect installation or weakness in wall structure.
Care must be taken in selecting a location for speaker installation
•
on a wall. Injury to personnel or damage to equipment may result
if the speakers installed interfere with daily activities.
This page is for
Red
White
Green
Blue
Surround speakers
SP-THM505S
(Bottom)
10 m
Route the speaker cord
through the hole on the
bracket.
Advertisement
Table of Contents
