Basic Settings; Operating Procedure; Setting The Digital Input (Digital In) Terminals-Digital In - JVC RX-ES9SL Instructions Manual

Basic settings

Operating procedure

TV DIRECT SETTING ADJUST SURROUND
DVD MULTI
STANDBY / ON STANDBY
On the front panel ONLY:
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
MULTI JOG now works for the setting operation.
2
Turn MULTI JOG until the setting item you want
to set appears on the display, then press SET.
• As you turn MULTI JOG, the indication changes as follows:
ANALOG L R
SUBWFR
SUBWFR FRNT SP
SURR SP CNTR DL
LFE
CROSS
DIGITAL IN*
QUICK SETUP
* Setting item you can select appears on the display after
"DIGITAL IN" appears for a few seconds.
3
Turn MULTI JOG to select the appropriate setting
for the item selected in step 2 , then press SET.
Your setting is stored.
ANALOG L R
SUBWFR
Ex.: When selecting "1VR2STB3DVD" for "DIGITAL IN."
15-20_RX-ES9SL[B]f
SOURCE SELECTOR MASTER VOLUME
/ MULTI JOG
SET / TUNER PRESET
DVD STB VR TV FM / AM
VOL
CNTR SP
SURR DL
D.COMP
AUTO SR
MODE
(Back to the beginning)
VOL
19
Setting the digital input (DIGITAL IN)
terminals—DIGITAL IN
When you use the digital input terminals, register what components
PHONES
are connected to which terminals—DIGITAL 1/2/3 (see page 7) so
that the correct source name will appear when you select the digital
source.
1VR2STB3DVD*: Select when connecting the following components;
DIGITAL 1: VR (VDR)
DIGITAL 2: STB
DIGITAL 3: DVD player
1VR2DVD3STB: Select when connecting the following components;
DIGITAL 1: VR (VDR)
DIGITAL 2: DVD player
DIGITAL 3: STB
1STB2VR3DVD: Select when connecting the following components;
DIGITAL 1: STB
DIGITAL 2: VR (VDR)
DIGITAL 3: DVD player
1STB2DVD3VR: Select when connecting the following components;
DIGITAL 1: STB
DIGITAL 2: DVD player
DIGITAL 3: VR (VDR)
1DVD2VR3STB: Select when connecting the following components;
DIGITAL 1: DVD player
DIGITAL 2: VR (VDR)
DIGITAL 3: STB
1DVD2STB3VR: Select when connecting the following components;
DIGITAL 1: DVD player
DIGITAL 2: STB
DIGITAL 3: VR (VDR)
* Initial setting
03.6.27, 16:49
19