Install the AP300
To complete AP300 installation, you need the items listed below.
Installation Type
Horizontal mounting
Vertical mounting over a wall
stud
Vertical mounting on sheetrock
Horizontal mounting below a
hanging ceiling
Using existing third party
brackets
Additional Equipment
A power source is needed to power the AP300. Available options are:
External ACC-AP300-PWR power supply
802.3af compliant PoE device
Pre-standard 802.3at compliant PoE device
AP150, AP200, and AP300 work with all switches that support standard 802.3af.
Install the AP300
Select a Location
All AP300 interconnected equipment must be contained within the same building, including the inter-
connected equipment's associated LAN connection. In addition, the AP300 should be mounted in a loca-
tion that meets the following conditions:
10
Meru Access Point Installation Guide
Consumable Items Required
None
Two #6 x 2" wood screws for a wood stud; or
Two #6 x 1½" metal screws for a metal stud
Mounting bracket
Two #6 x 1" screws
Two #4-6 x 7/8" ribbed plastic wall anchors
Mounting bracket
Two caddy fasteners
Two plastic spacers
Two keps nuts (with attached lock washer)
Mounting bracket
Use included shoulder screws
© 2009 Meru Networks, Inc.