Air Bleed Operation; Add Brake Fluid; Brake Lining - Sym Joyride 125 Service Manual

Air Bleed Operation

Connect a transparent hose to draining valve.
Hold the brake lever and open air bleeding valve.
Perform this operation alternative until there is
no air inside the brake system hoses.
Caution
Before closing the air bleed valve, do not
release the brake lever.

Add Brake Fluid

Add brake fluid to UPPER limit lever.
Recommended brake fluid: DOT3 or DOT4
WELL RUN brake fluid.
Caution
Never mix or use dirty brake fluid to prevent
from damage brake system or reducing
brake performance.

Brake Lining

The indent mark on brake lining is the wear
limitation.
Replace the brake lining if the wear limit mark
closed to the edge of brake disc.
Caution
It is not necessary to remove brake hose
when replacing the brake lining.
Remove the brake clipper bolt, and take out the
clipper.
Caution
Do not operate the brake lever after the
clipper removed to avoid clipping the brake
lining.
Pry out the brake lining with a flat driver if lining
is clipped.
To this chapter contents
Brake
caliper
Caliper
bolt
2. Maintenance Information
Drain valve
Air bubble
LOWER
Transparent hose
Master cylinder
cap
Plate
diaphragm
Diaphragm
UPPER
Lining
Brake disk
2-9