Sym Joyride 125 Service Manual page 161

9. V-Belt Drive System
Clutch weight replacement
Remove snap and washer, and then remove
clutch weight and spring from driving plate.
Caution
Some of models are equipped with one
mounting plate instead of 3 snap rings.
Check if spring is damage or insufficient
elasticity.
Check if shock absorption rubber is damage or
deformation. Replace it if necessary.
Apply with grease onto setting pins.
Install new clutch weight onto setting pin and
then push to the specified location.
Apply with grease onto setting pins. But, the
clutch block should not be greased. If so, replace
it.
Caution
Grease or lubricant will damage the clutch
weight and effect the block's connection
capacity.
Install the spring into groove with pliers.
9-12
To this chapter contents
Spring
Clutch weight
Shock absorption
rubber
Clutch
weight
Shock absorption
rubber
Spring
Driving
plate
Snap ring
Setting pin