SECONDARY TRANSMISSION
Replacing the bearings of the relay box
Crankcase
Wear gloves in order not to get burnt.
- Remove the seal.
- Using a heat gun, heat the crankcase to a
temperature between 80 and 90°C.
- Use an inertia type extractor tool to remove
the bearings.
- While the casing is expanded fit the new
bearing fully home in its housing.
- Using fitting tool P/N 757990, fit a new lightly
greased gasket (1).
Relay box cover
- Remove the seal.
- Place the cover on its gasket seat surface,
heat it (80 to 90°C) until the bearing falls out
by itself.
- While the casing is expanded fit the new
bearing fully home in its housing.
- Using fitting tool P/N 759788, fit a new lightly
greased gasket (2).
18
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
757990
1
759788
2