Radiocontrolled Auxiliary Output; If Both Radio Controls Are Lost; Loss Of The Personal Code (Pin); Radio Control Battery Low - Cobra Bridge compact alarm Fitting Instruction And User Manual

R
RADIOCONTROLLED AUXILIARY OUTPUT (If activated) RADIOCONTROLLED AUXILIARY OUTPUT (If activated)
RADIOCONTROLLED AUXILIARY OUTPUT (If activated) RADIOCONTROLLED AUXILIARY OUTPUT (If activated) RADIOCONTROLLED AUXILIARY OUTPUT (If activated)
With this function active you can ope-
rate the boot opening from the radio
control pressing button B. Of course
it will be possible if the vehicle is
already equipped with the internal
switch for the boot opening. The
function works only when the alarm
is unset to avoid undesidered
operations while the car is running.
If you use this wire as indicated it will not be possible anymore to connect an additional siren
PANIC ALARM PANIC ALARM
PANIC ALARM PANIC ALARM PANIC ALARM
Each time button B on the radio control is pressed with the system armed, an alarm cycle
will be generated, the siren will sound and the turn indicators will blink for 10 seconds.
Press any buttons to interrupt the panic alarm.
Panic feature will operate only 40 seconds after the alarm has been armed.
ALARM MEMORY ALARM MEMORY ALARM MEMORY ALARM MEMORY ALARM MEMORY
If an alarm has occurred the buzzer and the turn indicators will give four signals
instead of one.
The alarm description information is given by different LED blinking, which will be
available until the ignition key will be turned ON. See the table below.
LED SIGNAL
1 blink doors, bonnet, boot have been opened
2 blinks additional sensor triggered
3 blinks ultrasonic volumetric sensor triggered
4 blinks attempts to start (ignition key)
5 blinks voltage drop sensor triggered
6 blinks tamper mode
7 blinks serial line communication error
8 blinks serial line communication error
18
GB
mod. 7777
A
B
B
ALARM DESCRIPTION

IF BOTH RADIO CONTROLS ARE LOST

IF BOTH RADIO CONTROLS ARE LOST
IF BOTH RADIO CONTROLS ARE LOST IF BOTH RADIO CONTROLS ARE LOST IF BOTH RADIO CONTROLS ARE LOST
If both radio controls are lost you will still be able to proceed with emergency deactivation.
A Please refer to the emergency procedure at page 14.
mod. 7727

LOSS OF THE PERSONAL CODE (PIN)

LOSS OF THE PERSONAL CODE (PIN) LOSS OF THE PERSONAL CODE (PIN) LOSS OF THE PERSONAL CODE (PIN) LOSS OF THE PERSONAL CODE (PIN)
As the personal code represent the only possible access to the system, it should not be
left in the unattended vehicle since it could be used to form unauthorized combinations
with new radio controls or to disarm the system. If lost please contact your installer.

RADIO CONTROL BATTERY LOW

RADIO CONTROL BATTERY LOW RADIO CONTROL BATTERY LOW RADIO CONTROL BATTERY LOW RADIO CONTROL BATTERY LOW
When the radio control battery becomes low, the radio control LED will blink in an
irregular way or once only instead of remaining permanently ON until the button is
released. Replace the battery.

REPLACE THE BATTERY

REPLACE THE BATTERY REPLACE THE BATTERY REPLACE THE BATTERY REPLACE THE BATTERY
1. 1. 1. 1. 1. To change the battery ,open the radio
control as indicated in the figure,
levering in the zone marked "OPEN".
2. 2. 2. 2. 2. Remove the old battery as indicated.
4. 4. 4. 4. 4. Wait for 10 seconds about.
5. 5. 5. 5. 5. Open the pack with the new battery.
Only touch it on its sides with the
fingers.
Insert the new battery, remembering
to comply with the polarity
indications (+sign upwards,as shown
in the figure).
6. 6. 6. 6. 6. Close the radio control and press two
times the A button checking the
correct system operation.
Dispose the old battery in the special containers. Dispose the old battery in the special containers. Dispose the old battery in the special containers. Dispose the old battery in the special containers. Dispose the old battery in the special containers.
RE-SYNCHRONIZE THE RADIO CONTROLS RE-SYNCHRONIZE THE RADIO CONTROLS RE-SYNCHRONIZE THE RADIO CONTROLS RE-SYNCHRONIZE THE RADIO CONTROLS RE-SYNCHRONIZE THE RADIO CONTROLS
If the remote control does not work proceed as follow:
A) A) A) A) A) Press both buttons on the radio control until the LED will go OFF. Released them.
(The LED will remain permanently ON).
B) B) B) B) B) Press button A of the radio control - the LED will flash -. This should complete re-
synchronisation.
C) C) C) C) Press button A of the radio control again to verify that the product work properly. C)
mod. 7777
mod. 7727
GB
R
19