Installation Environment - Canon Laser Shot LBP3500 Getting Started Manual

■ Duplex Unit
The duplex unit DU-67 enables you to perform automatic 2-sided printing. The
duplex unit is to be installed on the rear of the printer unit. The duplex unit can
perform automatic 2-sided printing on plain paper (60 - 90 g/m
standard paper sizes (A3, B4, A4, B5, A5, Ledger (11 x 17), Legal, Letter,
Executive, 8K, and 16K) and plain paper of the following custom paper sizes.
• When loading paper in portrait orientation: Width 210.0 to 297.0 mm; Length
210.0 to 431.8 mm
•
When loading paper in landscape orientation: Width 210.0 to 297.0 mm;
Length 148.0 to 297.0 mm
■ Network Board
The network board fits inside the printer and is compatible with the TCP/IP
protocol for connecting the printer to LAN. The network board enables the
operation of the printer using a built-in web browser "Remote UI" allowing you
to specify settings and manage the printer from a computer on the network.
Also, you can use "NetSpot Device Installer" and "NetSpot Console" that
configure and manage a printer connected to a network on a computer.
Network board (NB-C1/NB-C2)
4
2
) of the
Duplex Unit DU-67
1 0 0
L N K
E R R
Environments

Installation Environment

In order to use this printer in a safe and comfortable manner, install the printer in
a place that fulfills the following conditions.
IMPORTANT
Before installing the printer, be sure to read "Important Safety Instructions"
(See User's Guide).
CD-ROM
● Use power supplies rated for the following voltages.
220 - 240 V (± 10 %) 50/60 Hz (± 2 Hz)
● The maximum power consumption of this printer is 1547 W* or less. Electrical
noise or a dramatic drop in mains voltage may cause the printer to operate
incorrectly or lose data, and can also cause the computer to fail.
* The instantaneous peak on startup shall not be counted.
● Use the printer in a location where the temperature and humidity are in the
following ranges.
Ambient temperature: 10 to 32.5°C (50 to 90.5°F)
Ambient humidity: 20 to 80 % RH (no condensation)
IMPORTANT
Water droplets (condensation) may form inside the printer under the
following circumstances. Leave the printer for two hours or more to adjust
the surrounding temperature and humidity before using it. If water droplets
form inside the printer, the paper transport path will not function properly,
and this may result in paper jams, damage to the printer, or printer error.
- When the room where the printer is installed is heated rapidly
- When the printer is moved from a cool or dry location to a hot or humid
location
NOTE
To customers using an ultrasonic humidifier
If you use an ultrasonic humidifier in conjunction with tap water or well
water, impurities in the water will be dispersed through the air. These can
be trapped inside the printer, causing degradations in printing quality.
When you are using these humidifiers, it is therefore recommended that
you use purified water or other water that is free of impurities.