Canon Laser Shot LBP3500 Getting Started Manual page 51

Parts and Their Functions
a
f
a a a a Printer Connector
Connects to the printer. Do not touch the connector directly with your
hands.
b b b b LAN Connector
Connects to a 10BASE-T/100BASE-TX LAN cable.
c c c c 100 Indicator (Green)
Comes on when the network board is connected to the network by
100BASE-TX. Does not come on when connected by 10BASE-T.
LNK Indicator (Green)
d d d d
Comes on when the network board is connected to the network properly.
ERR Indicator (Orange)
e e e e
Comes on or blinks when the network board is not working properly.
MAC Address
f f f f
It is required when setting the IP address using the ARP/PING command.
It may be also required when installing the printer driver.
IMPORTANT
The MAC address for NB-C1 can be found at the location of (A).
(A)
1 0 0
L N K
E R R
e d c b
1 0 0
L N K
E R R
Installing the Network Board
Install the network board in the expansion slot of the printer using the
following procedure. A Phillips screwdriver is required for installing the
network board. Have a screwdriver ready in advance that matches the size of
the screws.
NOTE
This network board does not come with a LAN cable. A Category 5 twisted
pair cable is required for installing the network board and connecting the
printer to a network. Have cables or a hub ready as needed.
1
Turn the printer and computer OFF a, remove the USB
cable b, and then disconnect the power plug from the AC
power outlet c.
a
2
Remove the power cord.
If there is not enough space to install the network board, move the printer to a
place where you can work easier.
c
b
a
51
Step
6